Industrial-data-systems IDS DT220 Bedienungsanleitung PDF herunterladen (Seite 36)

DT220 Users Manual version 1.a Configuration Parameters

System initialize, save Cal.

Use this function to reset DT220 parameters to factory default values. Calibration factors

are NOT changed.

System initialize

Use this function to reset DT220 parameters to factory default values. CALIBRATION

FACTORS WILL BE ERASED.

Database initialize

Use this function to erase all ID records.

System & Database initialize

Use this function to reset DT220 parameters to factory default values and erase all ID

records.

Download New Firmware

Use this function to update DT220 firmware. This function should be used by an

authorized IDS dealer or the factory only.

Set Time and Date

When the DT220 is in idle mode (not configuration mode) press the Shift key and then

the function Time Date key use 24 hour time to set the hour, i.e. if it is 3:40 pm enter 15

for the hour. Use the Cont.(↓

↓↓

↓) and Review(↑

↑↑

↑) keys to position the edit block to a time

value. Use the numeric keypad to enter a new value. Press the Enter key to complete the

entry. Position the edit block to Set Time and then press the Enter key to set the clock.

Press Function key Time Date to display time and date for 10 seconds. Press the Shift

key and then Function F4 key to display time in large character format.

NOTE: The clock speed can be adjusted in the Event Monitor section of the

configuration menu.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 48 49

Keine Kommentare

Industrial-data-systems IDS DT220 Bedienungsanleitung Seite 36